abrading

英 [əˈbreɪdɪŋ]

美 [əˈbreɪdɪŋ]

v.  磨损(岩石等); 擦伤(皮肤等)
abrade的现在分词

化学

柯林斯词典

• VERB 磨损；磨蚀；擦伤
  Toabradesomething means to scrape or wear down its surface by rubbing it.
  1. My skin was abraded and very tender.
     我擦破皮了，一碰就疼。

双语例句

• The diameter of the abrading section is required to be measured for abrasion analysis of the drill pipe. The traditional contact measurement is unefficient and has big human error.
  在石油钻井中，对钻杆的磨损分析需要测量磨损部位的直径尺寸，传统的接触式测量方法效率低，人为误差大。
• Pointing to the real time monitoring and control of small circular vibration of the main vibration platform in graphite electrode abrading machine, the vibration of the main vibration platform in X, Y axis is detected by a eddy transducer with two probes.
  针对石墨电极研磨机主振台微圆周振动轨迹实时监测与控制的要求，采用了双测头电涡流传感器分别检测主振台X、Y向的振动。
• Noting the following device can effectively cut an abrading of cluth.
  注意以下方法可以有效减少离合器的磨损。
• This paper analyzes mechanism of ear abrading, points out that abradant abrading and adhesion abrading is main way for ear abrasion, introduces the design principle of ear abrasion and the method of improving ears service life.
  分析了耳轴磨损机理，指出粘着磨损和磨料磨损是耳轴磨损的主要方式，介绍了耳轴磨损设计应遵循的原则和提高耳轴寿命的方法。
• In order to customise the test to your requirements, choose from a wide variety of abrading wheels and abraser accessories to simulate real-life wear conditions.
  为了自定义的测试您的要求，选择从磨石配件种类繁多的研磨轮，以模拟真实的磨损情况。
• This article narrated the structure and aPPlication result of the new type machine which abrading twenty square Porcelain.
  本文主要叙述了新型二十头瓷质磨砖边方形机组的结构和应用效果。
• Development and Research of Digital Control System on Graphite Electrode Abrading Tool
  基于RP技术的石墨电极研磨成形机控制系统开发与研究
• Therefore area array CCD is adopted for the non-contact measurement of the diameter of the abrading section of the drill pipe.
  鉴于此，采用面阵CCD对钻杆受磨损部位的直径进行非接触式测量。
• Objective To investigate the clinical efficacy of high-speed electric burr abrading procedure for inferior turbinate bone hypertrophy.
  目的探讨高速电钻下鼻甲骨磨削术治疗下鼻甲肥大的临床效果。
• Abrading Technique of the Whole-Bodied Graphite Electrode for Electrical Discharge Machining Based on Rapid Prototyping Technology
  基于快速成型技术的电火花加工用石墨电极研磨技术